Hioki 3504-40 C HiTester, Instruction Manual

Page: 260 / 292

8.13 Device Document Requirements (Only for Models 3504-50, 3504-60)
254
(15) Use/non use of the macro command
In the case of the macro command being executed, the maximum macro label
length, the maximum block length used to define the macro, and how to process
reflection when extending the macro.
The macro command is not used.
(16) Explanation of queries related to the identification and response for
the * IDN? query
These are defined in 8.9.1 "Common Commands" (p. 173).
(17) Capacity of the user data storage area protected by executing the
* PUD command and * PUD? query
The
*
PUD command and
*
PUD? query are not used. Furthermore, there is no
user data storage area.
(18) Explanation of resources when the
*
RDT command and
*
RDT? query
are used
The
*
RDT command and
*
RDT? query are not used. Furthermore, there is no
user data storage area.
(19) Explanation of effect of
*
RST,
*
LRN?,
*
RCL?, and
*
SAV
*
LAN?,
*
RCL?, and
*
SAV are not used. The
*
RST command returns the unit to
the initial state.
(Refer to 8.9.1 "Common Commands" (p. 173), 8.10 "Initialized Items" (p. 245).)
(20) Explanation of the range of the self test executed by the
*
TST? query
This is included in the section on " * TST?" (p. 173) in 8.9.1 "Common Com-
mands".
(21) Explanation of additional structure for the status data used in the sta-
tus report of the Device
This is included in 8.6.4 "About Event Registers" (p. 149).
(22) Explanation of whether each command is an overlap or sequential
command
All commands except :MEASure?, :MEMory?, :CORRection:OPEN, :CORRec-
tion:SHORt, and :CORRection:LOAD are sequence commands.
(23) Explanation of criteria related to the function requested when an oper-
ation end message is generated as a response for a command
The operation end message is generated when the command is analyzed.