Hioki 3504-40 C HiTester, Instruction Manual

Page: 135 / 292

7.4 About Measurement Times
129
9
7
End of Measure-
ment Signal
EOM
The output time (
T4
) for an end of measurement signal (EOM) can be obtained
by the following equation.
T4 = A(1 or 2) + B + C + D
A
Measurement time during normal measurement mode, no open/short circuit
compensation, HOLD range (contact check: OFF, trigger simultaneous output
function: disabled)
(1) No request for self calibration
(Allowable tolerance:
±
5%
±
0.5 ms)
(2) Request for self calibration
B
The calculation time differs depending on whether or not there is open circuit,
short circuit, or load compensation
C
The calculation time differs if comparator is executed.
D
The calculation time differs if BIN is executed. (Only for 3504-50, 3504-60)
Measurement Frequency
Measurement Speed
FAST (ms) NORM (ms) SLOW (ms)
120 Hz 10.0 37.5 146.0
1 kHz 2.0 5.5 29.5
Measurement Frequency
Measurement Speed
FAST (ms) NORM (ms) SLOW (ms)
120 Hz 25.8 43.2 148.2
1 kHz 4.8 7 30
Open Circuit, Short Circuit and
load Circuit Compensation
(ms)
No 0.0
Yes Max. 0.4 Each
Measurement Mode (ms)
Normal measurement mode 0.0
Comparator Measurement Mode MAX 0.4
Measurement Mode (ms)
Normal measurement mode 0.0
BIN Measurement Mode MAX 0.4
The output time for an analog measurement signal (INDEX) will be delayed by
the execution of the contact check. Accordingly the output time for an end of
measurement signal (EOM) will be delayed by the increase of delay time of
INDEX output.