The
L2CAP Set Initial Decoder Parameters
dialog requires the following user inputs to complete a
Parameter :
l
Stream
- This identifies the role of the device initiating the frame (master or slave)
l
Channel ID
- The channel number 0 through 78
l
Address
- This is the physical connection values for the devices. Each link in the net will have an address.
A piconet can have up to seven links. The
Frame Display
can
provide address information.
l
Data Source (DS) No.
-When only one data source is employed,
set this parameter to 0 (zero), otherwise, set to the desired data
source number.
Carries (PSM)
- Select the protocol that L2CAP traverses to from the
following:
l
AMP Manager
l
AMP Test Manager
l
SDP
l
RFCOMM
l
TCS
l
LPMP
l
BNEP
l
HCRP Control
l
HCRP Data
l
HID
l
AVCTP
l
AVDTP
l
CMTP
l
MCAP Control
l
IEEE P11073 20601
l
-Raw Data-
Adding, Deleting, and Saving L2CAP Parameters
1. From the
Set Initial Decoder Parameters
window, click on the
L2CAP
tab.
2. Set or select the
L2CAP
decoder parameters.
3. Click on the
ADD
button. The Initial Connection window displays the added parameters.
TELEDYNE LECROY
Chapter 3 Configuration Settings
24
Frontline BPA low energy Hardware & Software User Manual
Summary of Contents for BPA LOW ENERGY
Page 1: ...Hardware and Software User Manual Revision Date 1 3 2017...
Page 222: ......
