Extreme Networks ExtremeWare 7.7, Command Reference Manual

Page: 760 / 2620

760 ExtremeWare 7.7 Command Reference Guide
Commands for Status Monitoring and Statistics
enable flowstats filter ports
enable flowstats filter <filter#> ports <portlist> {ingress | egress}
Description
Enables a specified flow record filter for the specified ports.
NOTE
This command is available only on the “i” series switches.
Syntax Description
Default
For the PoS module, filter #1 is enabled on all SONET ports, and the remaining filters are disabled.
For other switches or modules, filters are enabled by default when they are configured.
Usage Guidelines
The
filter
# parameter is an integer in the range [1-8]. A filter must be enabled to match a flow. For “ i ”
series devices other than the PoS module, these apply only to outbound flows.
For each SONET port on a PoS module, sixteen filters are supported—eight filters for ingress flows and
another eight filters for egress flows. The
filter
# parameter and either the
ingress
or
egress
keyword are used to identify the particular filter that is being disabled.
One of either the
ingress
or
egress
keywords are required for SONET ports.
Example
The following command enables filter 3 for ports 1-8 on the switch:
enable flowstats filter 3 ports 1-8
History
This command was first available in ExtremeWare 6.1.5b20 for the PoS module only.
This command was first available in ExtremeWare 6.2 for all “ i ” series platforms.
filter# Specifies the flow record filter that should be enabled.
portlist Specifies the ports or slots and ports for which the filter should be enabled. May be in the form 1, 2,
3-5, 2:5, 2:6-2:8.
ingress Use this keyword to specify that the filter being enabled or disabled is one of the eight filters to be
applied to inbound flows on the SONET port(s).
NOTE: This option is available only on the PoS module.
egress Use this keyword to specify that the filter being enabled or disabled is one of the eight filters to be
applied to outbound flows on the SONET port(s).
NOTE: This option is available only on the PoS module.