Extreme Networks ExtremeWare 7.7, Command Reference Manual

Page: 2284 / 2620

2284 ExtremeWare 7.7 Command Reference Guide
PoS Commands—BlackDiamond Switch Only
configure aps delete
configure aps <group#> delete <port>
Description
Deletes a SONET port from an APS group.
Syntax Description
Default
N/A.
Usage Guidelines
You specify the
group#
parameter, which is an integer in the range [1-65535]. The
group#
identifies the
APS group that the port is to be deleted from. You also specify the
port
parameter, which identifies the
SONET port that is to be deleted from the APS group. If you delete the working line from a group, it
causes a switch to the protection line; however, if you delete an active protection line from a group, it
does not initiate a switch to the working line.
Example
The following command example deletes port 1 of the module installed in slot 8 of the BlackDiamond
switch from APS group 1001:
config aps 1001 delete 8:1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
group# Specifies the APS
group#
to which the command applies.
port Specifies the port number.