Extreme Networks ExtremeWare 7.7, Command Reference Manual

Page: 1338 / 2620

1338 ExtremeWare 7.7 Command Reference Guide
Wireless Commands
configure wireless ports interface transmit-power
configure wireless ports <portlist> interface [1 | 2] transmit-power
<level>
Description
Configures the power-level for the specified interface.
Syntax Description
Default
Full
Usage Guidelines
Each wireless port on the Summit 300 contains two interfaces. Interface 1 supports 802.11a, and
interface 2 supports 802.11b/g radio signals. The
configure wireless port interface
transmit-power
command allows you to configure one of the two individual interfaces (1|2) on a port
or ports. If there is radio interference from other devices, then you can adjust the power level to an
appropriate level below full power.
Example
The following command configures the power level to half-power for interface 1 on ports 5 to 16 on a
Summit 300-24:
configure wireless port 5-16 interface 1 transmit-power half
History
This command was first available in ExtremeWare 6.2a and added to the “ e ” series in 7.3e. In 7.4, the
command syntax was changed from c
onfigure wireless ports interface power-leve
l to
configure wireless ports interface transmit-power
.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p, and Alpine
switches.
portlist Specifies one or more ports or slots and ports. Can be one or more port numbers. May be in the form
1, 2, 1:2, 3-5, 2:*, 2:5, 2:6-2:8.
interface Specifies an interface: 1 or 2.
level Specifies the power level for the interface. Valid values are:
• Full
• Half
• Quarter
• One-eighth
• Min (minimum)