Extreme Networks ExtremeWare 7.7, Command Reference Manual

Page: 756 / 2620

756 ExtremeWare 7.7 Command Reference Guide
Commands for Status Monitoring and Statistics
disable transceiver-test
For an Alpine switch:
disable transceiver-test [all | slot <slot number> {backplane} ]
For a BlackDiamond switch:
disable transceiver-test [all | slot <slot number> | msm-a | msm-b | msm-c
| msm-d]
Description
Disables the integrity testing of the transceivers used for communication between the ASICs and the
CPU on an MSM or an SMMi module.
NOTE
This command is available only on modular switches.
Syntax Description
Default
Disabled
Usage Guidelines
To determine if you have the transceiver test enabled and the failure action the switch takes, use the
show switch
command. The following is sample transceiver test output:
Transceiver Diag: Enabled. Failure action: log only
To display the transceiver test statistics, use the
show diagnostics sys-health-check
command. The
following is sample output:
Transceiver system health diag result
Pass/Fail Counters Are in HEX
all Specifies all of the slots in the chassis.
slot number Specifies a single slot in the chassis.
backplane Specifies the backplane of the chassis.
NOTE: This option is available only on Alpine switches.
msm-a Specifies the MSM module installed in slot A.
NOTE: This option is available only on BlackDiamond switches.
msm-b Specifies the MSM module installed in Slot B.
NOTE: This option is available only on BlackDiamond switches.
msm-c Specifies the MSM module installed in slot C.
NOTE: This option is available only on BlackDiamond 6816 switches.
msm-d Specifies the MSM module installed in Slot D.
NOTE: This option is available only on BlackDiamond 6816 switches.