Extreme Networks ExtremeWare 7.7, Command Reference Manual

Page: 1215 / 2620

configure debug-trace pim-hello
ExtremeWare 7.7 Command Reference Guide 1215
configure debug-trace pim-hello
configure debug-trace pim-hello <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
NOTE
This command is available only on the “i” series switches.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The
debug level
range is 0 to 5. Higher levels record more verbose messages. Higher levels also
record the messages recorded at lower levels.
This command traces all PIM hello messages coming into a VLAN. Use this command if switches
connected to a common network have problems establishing or maintaining normal neighbor
relationships.
Example
The following command sets the reporting level for PIM hello errors to 3:
configure debug-trace pim-hello 3
Following is the log output at this level:
<INFO:SYST> msm-a-console admin: configure debug-trace pim-hello 3 vlan all
<INFO:SYST> Log cleared
<INFO:SYST> msm-a-console admin: clear log static
<DBUG:PIM> PIM: Receiving Hello pkt of len 18 from src 15.2.1.2 thro 15.2.1.1
<DBUG:PIM> PIM: Receiving Hello pkt of len 18 from src 15.1.4.2 thro 15.1.4.1
<DBUG:PIM> PIM: Xmitting Hello pkt of len 18 from src 15.2.1.1 to 224.0.0.13
<DBUG:PIM> PIM: Xmitting Hello pkt of len 18 from src 15.1.4.1 to 224.0.0.13
debug level Specifies a debug level:
0 — Records error messages.
1 — Records warnings.
2 — Records verbose warnings.
3 — Displays a dump of each packet.
4 — No additional information recorded.
5 — No additional information recorded.
vlan name Specifies a VLAN name.