Extreme Networks ExtremeWare 7.7, Command Reference Manual

Page: 2087 / 2620

show mroute
ExtremeWare 7.7 Command Reference Guide 2087
show mroute
show mroute
Description
Displays static multicast route configuration information.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
This command displays the static multicast table entries in the order defined with the
configure
mroute add
command. The following fields are displayed in the command output:
SrcAddr : Specifies the IP Address of the multicast source or RP.
SrcMask : Specifies the mask of the IP Address of the multicast source or RP.
rpfNbr : Specifies the next-hop address (multicast neighbor address) through which the source could
be reached.
The following flags are also displayed in the output:
U - Indicates that the interface through which the RPF neighbor could be reached is active.
m - Indicates that multicast is enabled on the interface through which the RPF neighbor could be
reached.
G - Indicates that the RPF neighbor is the gateway for this route.
Metric : Metric for the route. If the metric was not specified during configuration of this route (using
the
configure mroute add
command), the default value 0 would be displayed.
Proto : The protocol with which the route was configured using the
configure mroute add
command. If the protocol was not specified during the configuration of this route, ANY is displayed.
The asterisk "*" displayed along with each of the route indicates that the route is active. Otherwise, the
route is considered inactive and is not used.
Example
The following command displays static multicast route configuration information:
show mroute
---------------------------------------------------------------------
SrcAddr SrcMask rpfNbr flags metric Proto
---------------------------------------------------------------------