Dell PowerVault 720N, Command Reference Manual, Page: 95 / 606

Filer Administration Basics 2-37
Example: The following example shows how to activate several protocols with one
command:
OLFHQVHQIV $%&'()*&,)6 +,-./01KWWS 3456789
'LVSOD\LQJ&XUUHQW/LFHQVH&RGHV
To display licensing information, enter the
license
command without parameters,
as follows:
ILOHU!
license
QIV $%&'()*
FLIV QRWOLFHQVHG
KWWS 3456789
VQDSUHVWRUH QRWOLFHQVHG
7DEOHOLFHQVH&RPPDQG6HUYLFHRU)HDWXUH
6HUYLFHRU
IHDWXUH 0HVVDJHV
NFS QIVOLFHQVHHQDEOHG
QIVHQDEOHG
The filer also automatically runs the
nfs on
command to start
NFS service. However, the filer does not add the
nfs on
com-
mand to
/etc/rc
as a result of the
license
command. If you
want the filer to run NFS service after each reboot, add
nfs on
to
/etc/rc
.
CIFS &,)6OLFHQVHHQDEOHG
5XQFLIVVHWXSWRHQDEOH&,)6
To start CIFS service, set up the filer’s CIFS configuration by run-
ning
cifs setup
. You don’t need to run
cifs setup
after the
license
command if you already set up the CIFS configuration.
HTTP KWWSOLFHQVHHQDEOHG
8VH«RSWLRQVKWWSGHQDEOH¬WRHQDEOHKWWS
To start HTTP service, enter the following command:
RSWLRQVKWWSGHQDEOHRQ
Results: The
options
command takes effect immediately. If
you want the filer to automatically start HTTP service after each
reboot, add
options httpd.enable
to
/etc/rc
.
SnapMirror VQDSPLUURUOLFHQVHHQDEOHG
VQDSPLUURUHQDEOHG
SnapRestore VQDSUHVWRUHOLFHQVHHQDEOHG
VQDSUHVWRUHLVHQDEOHG