Q00110 Rev A 8/06
Page 56 of 225
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
4.
Remove the plastic covering and shrink wrap from the miniCart and container contents.
5.
Remove the small boxes (containing the
z.one
transducers and Scan Engine) from the container.
6.
On the container base, remove or cut the clear packing tape that secures the rear flap and unfold
the rectangle cardboard support at the rear of the system. This rear flap is partially glued and will
require a slight pull to release. This will provide an exit and slight ramp for removing the
miniCart from the base.
7.
Unlock the brakes (two front wheels), and firmly grasp the rear handle.
8.
Being careful to control the system’s momentum, gently roll/lift the system down the ramp and
off the base.
Note: Make sure that you are supporting the weight of the system while removing as the cardboard
mock-ramp is not designed to support the full weight of the miniCart
9.
Remove all protective plastic wrap and foam packaging materials.
10.
Inspect the entire
z.one
for damage, paying close attention to the LCD display on the
mini
Cart.
11.
Move the
z.one
to the installation area
.
5.5
Mechanical
Verification
STEPS:
1.
Perform a check to verify proper operation of all of the following mechanical components.
•
Ensure wheels and brakes function properly
•
Raise and lower the Cart (SuperCart or
mini
Cart) height adjuster (pull release lever
located on the right of the system), to verify smooth operation and positive locking
•
Ensure the LCD display monitor rotates and adjusts properly
SuperCart:
Содержание Z.ONE
Страница 1: ......
