Q00110 Rev A 8/06
Page 122 of 225
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
2.
Remove the Sony UP-21MD Color Printer, accessories, and cables from their packaging.
3.
Install the rubber grommet (30238) in the hole in the sheet metal, at the left/front (as viewed
from front of system) of the backpack.
Rubber
Grommet
4.
Install cable exit port rubber grommet (30223) in the following location, on the top/
right
of the
backpack (as viewed from the rear of the system).
Rubber
Grommet
Installation
5.
Lay the printer mounting bracket (30595) against the bottom surface of the printer (as shown),
aligning the four (4) holes in the plate with the four threaded mounting holes on printer.
6.
Using the Philips screwdriver (provided in the kit), install the four (4) Philips-head screws
(also provided in the kit), through the holes in the mounting bracket and into the threaded
mounting holes in the bottom of the printer.
7.
Using the 4mm Allen driver tool (provided in the kit), partially thread the three (3) button-head
Allen mounting plate retaining screws (31913) into the corresponding holes on the LEFT side
of the support frame of the SuperCart.
Содержание Z.ONE
Страница 1: ......
