ZONARE Z.ONE, Руководство по обслуживанию

Страница: 143 / 225

Q00110 Rev A 8/06 Page 143 of 225
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
16.4.7 MANUAL Log File Capture (During “System Lock-Up”) – Download to ZONARE
4. Ensure a USB Memory Stick is inserted into the port at the rear of the Scan Engine
5. In rapid (less than 1 second apart) succession, press the following three keys in sequence, on
the User Interface of the Scan Engine (or SuperCart):
6. System log file is generated and copied to internal CompactFlash storage
7. Power off the Z.ONE by holding down the Power button for several seconds, until system
shuts down
8. Power on the Z.ONE and allow it to fully boot
9. Return to the Diagnostic page, and follow the instructions provided in the earlier section on
downloading the files to the ZONARE FTP site
16.4.8 MANUAL Image File Capture (Store) – Download to ZONARE
NOTE :
The following process is used for capturing (and storing) an ultrasound image screen
snapshot as a .BMP file on the”LOG” directory of the removable USB Memory Stick card
inside the Scan Engine. The intent is for capturing, and then forwarding (via an FTP
transfer) digital images to Zonare for evaluation
Operate the system normally until the desired ultrasound image event has occurred, at which
time press “Freeze” to retain the image on the screen
.
1. Press the “SET” button to initiate the capture of the current ultrasound image screen,
and storing of the file to the LOG directory on the internal CompactFlash storage
2. To download the stored Image files to ZONARE Tech Support, enter the proper IP Address,
User Name, and Password values in the entry boxes on the screen (values as provided by
ZONARE Tech Support)
NOTE : The Scan Engine must be docked in the SuperCart and the
z.one
must be connected
and properly configured on a local IT network that WWW internet access, in order to
perform the remote system log file transfer to ZONARE.
Using the trackball, position the arrow cursor over the Send System Logs box, and press the “SET”
button to initiate the system log transfer
S
S
E
E
T
T
M
M
E
E
A
A
S
S
U
U
R
R
E
E
P
P
R
R
I
I
N
N
T
T