ZONARE Z.ONE, Руководство по обслуживанию

Страница: 212 / 225

Q00110 Rev A 8/06 Page 212 of 225
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
20.5 Hardware Service/Replacement Procedures (Scan Engine)
20.5.1 Rear I/O Door Assembly - Removal/Replacement (Scan Engine)
Required Parts
•
P/N: 80255-00 .......... Rear I/O Door Assembly (Zonare)
Required Tools
•
ESD protection equipment (wrist grounding strap, anti-static surface)
•
#2 Philips-head screwdriver
Procedure
STEPS:
1. Ensure the
z.one
is powered “OFF”
2. Remove the Scan Engine from the SuperCart (if currently docked)
3. Lay Scan Engine face-down
4. Remove battery pack from the Scan Engine
CAUTION
•
To prevent potential static shock damage to sensitive electrical components in
the Scan Engine, use of all proper ESD (Electro Static Discharge) protection
(wearing grounded wrist strap) and avoid direct contact with electronics during
replacement of the Rear I/O Access door.
5. Completely loosen the four (4) Philips-head screws, retaining the door to the Scan Engine
6. Grasping the hinged door, lift the door assembly out of the Scan Engine
7. Reverse above procedure for reinstallation, ensuring that the rubber boot (located inside the
doorway) is properly positioned prior to door installation