ZONARE Z.ONE, Руководство по обслуживанию

Страница: 169 / 225

Q00110 Rev A 8/06 Page 169 of 225
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
19.3.4 Transducer Problems
Transducer not recognized by system (no B-mode imaging)
•
To ensure a positive connection, disconnect the transducer and reconnect it.
•
To determine a problem with the transducer or system, attach a different transducer to the Scan
Engine.
•
Disconnect the transducer. Power down the Scan Engine. Power the Scan Engine back on, and
reinsert the transducer to test for functionality.
•
Remove the Scan Engine from the SuperCart, and repeat the transducer removal/installation
process.
•
If system still fails to operate any transducers, contact ZONARE Tech Support.
19.3.5 Battery Charging Problems
Battery does not charge in Scan Engine, when docked in SuperCart
•
Ensure AC power is present at SuperCart
•
Ensure circuit breaker at the rear of the SuperCart is in the up (“ON”) position
•
Verify DC voltages are present, by checking illumination of top 3 green LEDs at right/rear of
Main/IO board (at rear of SuperCart).
•
Battery discharge level may be too low (0%), to power internal battery intelligent electronics.
Perform the following sequence to achieve sufficient trickle charging to return battery to
workable state:
o
Undock Scan Engine from SuperCart, then re-dock again, leaving it for 30 seconds
o
Repeat this above dock/un-dock process (and delay), 3 more times
o
After third cycle, leave Scan Engine docked for 5 minutes to begin charging.
o After 5 minutes, un-dock Scan Engine and remove battery to check charge state to
verify charging process is now operational. If charging, re-dock Scan Engine and allow
1 hour for fully charging of the battery. If not, repeat previous dock/un-docking cycle
sequence.
19.3.6 Imaging Problems
No/poor B-mode image
•
Ensure that the brightness and/or contrast settings of the LCD display are set close to factory
default levels on the SuperCart. Default settings are indicated by the asterisk (*) in the pop-up
menu.