ZONARE Z.ONE, Руководство по обслуживанию

Страница: 128 / 225

Q00110 Rev A 8/06 Page 128 of 225
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
10. “Press” the jog dial control, and then “Roll” it to select which one of three possible user setup
types (1, 2 or 3) you wish to save.
11. “Press” the jog dial to save the desired user settings type
12. To manually exit out of the setup MENU, “Roll” the jog dial until “BACK” is displayed in the
setup menu window, and then “Press” the jog dial.
NOTE: The setup menu will exit, and automatically return to the normal “Ready” printer
state, when no new user actions are made on the jog dial for approximately 20
seconds.
# Setting Name Description Zonare Recommended Value
28
BEEP Audible Tone ON
29
CLEAN Initiate head cleaning operation n/a – control action in menu
30
COMD Selects printer driver version 897
31
DIR Direction (start top or bottom, for printing) NORMAL
32
FEED Added gap between prints ON
33
GAMMA Gamma curve (print density) 4
34
IMAGE Positive or Negative printout POS
35
INFO Printing of user settings on prints OFF
36
LOAD Loads stored settings 1, 2 or 3 into use n/a – control action in menu
37
MEDIA Paper type HG
38
MENU Prints out current user settings to paper n/a – control action in menu
39
QTY Number of copies to print 1
40
RSIZE Selects image enlargement to paper size ON
41
SAVE Saves settings (as user 1, 2 or 3) n/a – control action in menu
42
SHARP Sharpness: Image tuning (1-15) 4
43
SIDE Image rotation (Up or 90 degrees) SIDE
44
SPEED Print speed NORMAL
Figure 58: Menu Settings (UP-D897)
13. Using the Philips screwdriver (provided in the kit), remove the four screws that retain the
plastic feet to the bottom of the UP-D897 printer, but
DO NOT remove the rubber feet from to
the base of the printer.