YASKAWA MOTOMAN DX100, Руководство по обслуживанию, Страница: 647 / 729

8A
la
rm
DX100
8.3
A
la
rm Me
ssa
ge List
8-532
4569 UNDEFINED
PRESS
RESOLUTION
DATA Sub Code: Press characteristic file
number Setting error (1)Check the following settings.
·Set the press resolution data to be used in the job.
4571 SERVO FLOAT
MODE RELEASE
ERR Software operation
error occurred (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
4572 NO SERVO GUN
CONTROL
GROUP Setting error (1)Check the following settings.
·Set the "motor gun axis" in the control group setting of maintenance mode.
4573 SPOT WELDER
NO. ERROR Sub Code: Welder number Setting error (1)Check the following settings.
·Correct the welder number set in the gun characteristic file.
4574 SPOT WELD
COMPLETE TIME
LIMIT Sub Code: Welder number Setting error (1)Check the following settings.
·Turn ON the timer contactor power.
·If the response from the timer takes too long time due to the system layout,
increase the timeout time.
4575 ERROR IN WELD
START TIMING
SET Setting error (1)Check the following settings.
·Check the settings for the "WST" tag.
·Check the settings for the pressure file.
4576 ERR IN MOTOR
GUN CONT MODE Software operation
error occurred (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
4577 ERR IN MOTOR
GUN MODE
RELEASE Software operation
error occurred (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
Alarm
Number
Alarm Name Sub
Code
Meaning Cause Remedy