Yamaha RCX240, Руководство пользователя

Страница: 316 / 620

4
1
2
3
5
6
7
8
9
10
4-238
Chapter 4 OPERATION
12. "SYSTEM" mode
Chapter 4 OPERATION
4-239
n
NOTE
• Set the Board status parameter to "INVALID" when not using serial I/O boards.
• When the Board status parameter is set to "INVALID", the dedicated input/output
of the STD.DIO connector is enabled. When the Board status parameter is set to
"VALID", the dedicated input (except DI1) of the STD.DIO connector is disabled.
• For remote commands and I/O commands, refer to the command reference
manual.
• For a description of codes issued from the message output function for SOW(1),
refer to "1. Error messages" in Chapter 10.
• When the Remote command & I/O command parameter is set to "VALID", the
Output MSG to SOW(1) parameter cannot be set to "VALID". Likewise, when the
Output MSG to SOW(1) parameter is set to "VALID", the Remote command & I/O
command parameter cannot be set to "VALID".
• When the IO size is set to "Small" (2CH each of input/output), the I/O commands
can be used but the remote commands cannot be used. Note that use of the
I/O commands is partly limited.
• When the IO size is set to "Small" (2CH each of input/output), the "Output MSG to
SOW(1)" parameter function cannot be used.
ＳＹＳＴＥＭ ＞ＰＡＲＡＭ＞ＯＰ．ＢＲＤ Ｖ１０．０１
１． Ｄ＿Ｎｅｔ（Ｍ４／５００ｋ） ＶＡＬＩＤ
２． ＤＩＯ＿Ｎ（１） ＶＡＬＩＤ
３． −−−
４． −−−
ＳＥＬＥＣＴ
"Serial IO" setting (1)
1
In "SYSTEM>PARAM>OP.BRD" mode, select the desired serial I/O with
the cursor keys and press
(SELECT).
ＳＹＳＴＥＭ ＞ＰＡＲＡＭ＞ＯＰ．ＢＲＤ＞ＳＥＬＥＣＴ Ｖ１０．０１
１．ｂｏａｒｄ ｃｏｎｄｉｔｉｏｎ ＶＡＬＩＤ
２．ｒｅｍｏｔｅ ｃｍｄ ／ ＩＯ ｃｍｄ（ＳＩ０５） ＶＡＬＩＤ
３．Ｏｕｔｐｕｔ ＭＳＧ ｔｏ ＳＯＷ（１） ＩＮＶＡＬＩＤ
４．ＩＯ ｓｉｚｅ Ｌａｒｇｅ
ＥＤＩＴ ＪＵＭＰ
"Serial IO" setting (2)