Subaru 2009 IMPREZA, Руководство по обслуживанию

Страница: 2652 / 3619

PS-29
Steering Gearbox
POWER ASSISTED SYSTEM (POWER STEERING)
39) If the tie-rod end has been removed, screw in
lock nut and tie-rod end to the screwed portion of
tie-rod, and tighten the lock nut temporarily in a po-
sition as shown in the figure.
Installed tie-rod length L:
29 mm (1.14 in)
40) Inspect the gearbox as follows:
“A” Holding the tie-rod end, repeat lock to lock sev-
eral times as quickly as possible.
“B” Holding the tie-rod end, turn it slowly at a radius
several times as large as possible.
Finally, make sure that the boot is installed in the
specified position without inflating.
41) Remove the gearbox from ST.
ST1
926200000 STAND
ST2 34199AG000 BOSS D
42) Install the four pipes on gearbox.
(1) Connect the pipes A and B to the four pipe
joints of gearbox.
Tightening torque:
Refer to the component parts. <Ref. to PS-4,
POWER ASSISTED SYSTEM, COMPONENT,
General Description.>
(2) Connect the pipes C and D to gearbox.
Tightening torque:
Pipe C: 37 N·m (3.8 kgf-m, 27.3 ft-lb)
Pipe D: 29 N·m (3.0 kgf-m, 21.4 ft-lb)
L
PS-00097
B
A
PS-00098
(1) Pipe D
(2) Pipe C
PS-00525
(1)
(2)