Subaru 2009 IMPREZA, Руководство по обслуживанию

Страница: 2003 / 3619

4AT(diag)-18
Subaru Select Monitor
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
11) Follow the messages displayed on the Subaru
Select Monitor screen when working.
NOTE:
During AT learning in progress, SPORT indicator
light in the combination meter starts flashing at 2
Hz and the learning operation starts. The following
message is displayed on the screen when the
SPORT indicator light turns off.
12) “AT learning normally ended.” is displayed,
simple AT learning is completed.
NOTE:
• If communication error occurs during learning,
retry the “AT learning mode” from the beginning.
• If the message “Execute AT learning again after
fixing troubles of the vehicle” is displayed during
learning, select [OK] to display the List of Diagnos-
tics Trouble Code. After repairing the locations in-
dicated by the DTC, start the “AT learning mode”
over from the beginning.
• If the message “AT learning ended abnormally”
is displayed, start the “AT learning mode” over from
the beginning.
• When communication error occurs during learn-
ing, select lever does not shift occasionally. If se-
lect lever does not shift, turn the ignition switch to
OFF before operating the lever.
• For details concerning the operation procedure,
refer to “PC application help for Subaru Select
Monitor”.
Message Main reasons for abnormal termination
“AT learning ended abnormally” • A malfunction was detected during AT learning.
• The accelerator pedal is depressed during AT learning.
• Operation which is not directed is performed during AT learning.
• Brake pedal is not depressed fully.
• Parking brake not applied strongly enough.
• Abnormal idle speed increase,
etc.