Subaru 2009 IMPREZA, Руководство по обслуживанию

Страница: 3198 / 3619

EI-32
Front Bumper
EXTERIOR/INTERIOR TRIM
2. REPAIR INSTRUCTIONS FOR COLORED PP BUMPER
NOTE:
All PP bumpers are provided with a grained surface, and if the surface is damaged, it cannot normally be re-
stored to its former condition. Damages limited to the shallow scratches that cause only a change in the luster
of the base material or coating, can be almost fully restored. Before repairing a damaged area, explain this
point to the customer and obtain an understanding about the matter. Repair methods are outlined below,
based on a classification of the extent of damage.
1) Minor damage causing only a change in the luster of the bumper due to a light touch
Almost restorable.
2) Deep damage caused by scratching with fences etc.
A dent cannot be repaired but a whitened or swelled part can be removed.
Process
No.
Process name Job contents
1 Cleaning Clean the area to be repaired using water.
2 Sanding Grind the repairing area with #500 sand paper in a “feathering” motion.
3 Finish
Resin section Coated section
Repeatedly apply wax to the affected area
using soft cloth (such as flannel).
Recommended wax: NITTO KASEI Soft 99
TIRE WAX BLACK, or equivalent.
Perform either the same process as for the
resin section or process No. 18 and subse-
quent in the 3) section, depending on the
degree and nature of damage.
Polish the waxed area with clean cloth after 5
— 10 minutes.
Process
No.
Process name Job contents
1 Cleaning Clean the damaged area with water.
2
Removal of
damaged area
Cut off protruding area, if any, due to collision, using a putty knife.
3 Sanding Grind the affected area with #100 — #500 sand paper.
4 Finish
Resin section Coated section
Same as process No. 3 in the “1)” section.
Perform process No. 12 and subsequent oper-
ations in the “3)” section.