Subaru 2009 IMPREZA, Руководство по обслуживанию

Страница: 2249 / 3619

TPM(diag)-8
Subaru Select Monitor
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS)
5. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
1) Prepare the Subaru Select Monitor kit. <Ref. to
TPM(diag)-4, SPECIAL TOOL, PREPARATION
TOOL, General Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector is located in the lower
portion of instrument panel (on the driver’s
side).
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect the scan tools other than the
Subaru Select Monitor.
4) Turn the ignition switch to ON (engine OFF) and
run the Subaru Select Monitor.
5) On «Main Menu» display, select {Each System
Check}.
6) On «System Selection Menu» display, select
{Tire pressure monitor}.
7) On «Tire pressure monitor diagnosis» display,
select {Diagnostic Code(s) Display}.
NOTE:
• For details concerning the operation procedure,
refer to “PC application help for Subaru Select
Monitor”.
• For details concerning DTCs, refer to List of Di-
agnostic Trouble Code (DTC). <Ref. to TPM(diag)-
26, List of Diagnostic Trouble Code (DTC).>
• All DTCs detected will be displayed.
• If a particular DTC is not properly stored in mem-
ory (due to a voltage drop of the tire air pressure
monitor control module power supply, etc.) when a
problem occurs, a DTC suffixed with a question
mark will appears on the Subaru Select Monitor
display. This shows it may be an unreliable read-
ing.
8) If communication is not possible between the tire
pressure monitoring control module and the Suba-
ru Select Monitor, check the communication circuit.
<Ref. to TPM(diag)-11, COMMUNICATION FOR
INITIALIZING IMPOSSIBLE, INSPECTION, Suba-
ru Select Monitor.>
9) When DTC is not displayed, check the indicator
circuit and communication circuit. <Ref. to TPM(di-
ag)-14, WITHOUT DTC, INSPECTION, Subaru
Select Monitor.>
IM-00275