Subaru 2009 IMPREZA, Руководство по обслуживанию

Страница: 3155 / 3619

SL-51
Transmitter
SECURITY AND LOCKS
23.Transmitter
A: REMOVAL
1. TRANSMITTER BATTERY
CAUTION:
To prevent static electricity damage to the key-
less transmitter printed circuit board, touch the
steel area of building with hand to discharge
static electricity carried on body or clothes be-
fore disassembling the keyless transmitter.
Remove the battery (1) from the transmitter.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1. TRANSMITTER BATTERY
Measure the voltage between the keyless transmit-
ter battery (+) terminal and (–) terminal.
NOTE:
Battery discharge occurs during the measurement.
Complete the measurement within 5 seconds.
If NG, replace the battery. (Use CR2025 or equiva-
lent.)
D: REPLACEMENT
1. REGISTRATION OF KEYLESS
TRANSMITTER WITH SUBARU SELECT
MONITOR
NOTE:
• A maximum of four keyless transmitter can be
registered for each individual vehicle.
• When replacing or adding the keyless transmit-
ter, new registration of transmitter is necessary.
1) Connect the Subaru Select Monitor to the vehi-
cle.
2) Turn the ignition switch to ON.
3) From the «System Selection Menu» of the Sub-
aru Select Monitor, select the {2. Each System
Check}
o
{7. Integ. unit mode}
o
{8. Keyless ID
registration}.
4) Input the 8-digit ID number attached to the plas-
tic bag of the keyless transmitter or inside the trans-
mitter, from left to right, then press the [Enter] key.
NOTE:
Press the [
] key on the Subaru Select Monitor to
increase the number, and the [ ] key to decrease.
Press the [<] key to move to the digit in the left, and
[>] to the right.
5) The ID number you have entered will be shown.
Make sure that the ID number shown is the same
as that of plastic bag or inside of transmitter.
6) Press the [OK] key if the ID number is correct. If
the ID number is incorrect, select [NO] to return to
the step 3) and reenter the ID number.
7) «ID is being registered···» is displayed and reg-
istration starts.
8) «ID registration completed» will be displayed
when the registration process is done.
9) To exit, select «Quit: NO» to return to {8. Key-
less ID registration}. If there are additional keyless
transmitters to be registered, select «The following
are registered: OK» to return to the step 4).
NOTE:
• If the registration fails, «ID cannot register.
Please try again.» will be displayed. Select the [OK]
key to return to the {8. Keyless ID registration}. And
retry from the step 3).
• «Quit: NO» is shown on the Subaru Select Mon-
itor when fourth keyless transmitter has been regis-
tered. Select the [NO] key to return to {8. Keyless
ID registration}.
(A) Resistance (47
:
)
Tester connection
Standard
(+) (–)
Battery
Positive terminal
Battery
Ground terminal
2.5 — 3.0 V
(1)
SL-00387
(A)
SL-00066