Subaru 2009 IMPREZA, Руководство по обслуживанию

Страница: 1276 / 3619

EN(H4DOTC)(diag)-55
Compulsory Valve Operation Check Mode
ENGINE (DIAGNOSTICS)
14.Compulsory Valve Operation
Check Mode
A: OPERATION
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4DOTC)(diag)-7, PREPARATION TOOL,
General Description.>
2) Prepare PC with Subaru Select Monitor installed.
3) Connect the USB cable to SDI (Subaru Diagno-
sis Interface) and USB port on the personal comput-
er (dedicated port for the Subaru Select Monitor).
NOTE:
The dedicated port for the Subaru Select Monitor
means the USB port which was used to install the
Subaru Select Monitor.
4) Connect the diagnosis cable to SDI.
5) Connect the delivery (test) mode connector (A)
located under the glove box.
6) Connect SDI to data link connector located in the
lower portion of the instrument panel (on the driv-
er’s side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor and general scan tool.
7) Start the PC.
8) Turn the ignition switch to ON (engine OFF) and
run the “PC application for Subaru Select Monitor”.
9) On «Main Menu» display, select {Each System
Check}.
10) On «System Selection Menu» display, select
{Engine Control System}.
11) Click the [OK] button after the information of
engine type has been displayed.
12) On «Engine Diagnosis» display, select {Sys-
tem Operation Check Mode}.
13) On «System Operation Check Mode» display,
select {Actuator ON/OFF Operation}.
14) Select the desired compulsory actuator on the
«Actuator ON/OFF Operation» display screen and
click the [Next] button.
EN-05692
EN-06146
(A)
EN-06148