Rohde & Schwarz SMBV100A, Руководство по эксплуатации

Страница: 616 / 911

Remote Control Commands
R&S
®
SMBV100A
601 Operating Manual 1176.8016.02 ─ 17
7.16.3.2 SOURce:BB:ARB Subsystem
The ARB subsystem contains the commands for setting the ARB Generator. Settings
for clock and trigger interfaces and for external outputs are entered in the
SOURce:INPut
and
SOURce:OUTput
subsystems.
Section Chapter 7.4, "Waveform and List Format" , on page 511 describes the ARB
waveform format and how it is used to transmit waveforms via the IEC bus.
● Common Settings ..................................................................................................601
● Clock Settings ....................................................................................................... 602
● Trigger Settings .....................................................................................................604
● Marker Settings .....................................................................................................611
● Test Signals Settings ............................................................................................ 615
● SOURce:BB:ARB:MCAR Subsystem ................................................................... 618
● SOURce:BB:ARB:WAV Subsystem ......................................................................633
● SOURce:BB:ARB:WSEG Subsystem ...................................................................637
Common Settings
[:SOURce<hw>]:BB:ARBitrary:PRESet
............................................................................ 601
[:SOURce<hw>]:BB:ARBitrary:STATe
..............................................................................601
[:SOURce<hw>]:BB:ARBitrary:PRESet
Sets all ARB generator parameters to their default values.
Example: SOURce1:BB:ARB:PRESet
Usage: Event
Manual operation: See "Set To Default" on page 386
[:SOURce<hw>]:BB:ARBitrary:STATe <State>
Activates the standard and deactivates all the other digital standards and digital modu-
lation modes in the same path.
You have to selecta an waveform first.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example: SOURce1:BB:ARBitrary:WAV:SELect 'wave1'
loads waveform file from the default directory.
SOURce1:BB:ARBitrary:TRIGger:SEQ RETR
sets trigger mode Retrigger.
SOURce1:BB:ARBitrary:STATe ON
switches on the ARB generator. The selected waveform is out-
put straight away. A trigger event causes restart.
Manual operation: See "State (ARB)" on page 385
SOURce Subsystem