Rohde & Schwarz SMBV100A, Руководство по эксплуатации

Страница: 809 / 911

Remote Control Commands
R&S
®
SMBV100A
794 Operating Manual 1176.8016.02 ─ 17
Example: POW:SPC:SEL SENS2
selects the sensor connected to a second USB interface for
power control.
Manual operation: See " Sensor " on page 230
[:SOURce<hw>]:POWer:SPC:STATe <PowCntrlState>
Activates power control using the selected sensor. The control loop periodically adjusts
the generator output. After switching off, the running loop is completed.
Parameters:
<PowCntrlState> 0 | 1 | OFF | ON
*RST:
0
Example:
POW:SPC:STAT ON
activates power control.
Manual operation: See "State" on page 230
[:SOURce<hw>]:POWer:SPC:TARGet <PowCntrlTarget>
Sets the nominal level expected at the input of the sensor. To define the unit of the
power value, use command
:SENSe<ch>:UNIT[:POWer]
on page 588.
Parameters:
<PowCntrlTarget> float
Range:
-50 to 30
Increment: 0.01
*RST:
-10
Example: SENS:UNIT dBm
selects unit dBm for setting the target level value.
POW:SPC:TARG -10
sets -10 dBm target level.
Manual operation: See "Target Level" on page 231
[:SOURce<hw>]:POWer:STARt <Start>
Sets the start level for the RF sweep.
Note: You can select any level within the setting range. The range is defined by this
start value and the
[:SOURce<hw>]:POWer:STOP
value.
A defined offset (
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet
)
affects the level values according to the formula:
Minimum level + OFFSet ... Maximum level + OFFSet
SOURce Subsystem