![Rohde & Schwarz SMBV100A Скачать руководство пользователя страница 859](http://html1.mh-extra.com/html/rohde-and-schwarz/smbv100a/smbv100a_operating-manual_1477735859.webp)
Remote Control Commands
R&S
®
SMBV100A
844
Operating Manual 1176.8016.02 ─ 17
....................................................................................847
:TRIGger<hw>[:SWEep][:IMMediate]
................................................................................848
............................................................................................. 849
:TRIGger<hw>:FSWeep:SOURce
<Source>
Sets the trigger source for the RF frequency sweep.
The names of the parameters correspond directly to the various settings under manual
control. SCPI uses other names for the parameters; these names are also accepted by
the instrument. The SCPI names should be used if compatibility is an important consid-
eration.
An overview of the various names is given in
Parameters:
<Source>
AUTO | IMMediate | SINGle | BUS | EXTernal | EAUTo
AUTO|IMMediate
The trigger is free-running, i.e. the trigger condition is fulfilled
continuously. As soon as one sweep is finished, the next sweep
is started.
SINGle|BUS
One complete sweep cycle is triggered by the GPIB commands
[:SOURce<hw>]:SWEep[:FREQuency]:EXECute
TRIGger<hw>:FSWeep[:IMMediate]
*TRG
. The mode
has to be set to
AUTO
(
:SOURce:SWEep:FREQuency:MODE
AUTO
).
EXTernal
The sweep is triggered externally via the INST TRIG connector.
EAUTo
The sweep is triggered externally via the INST TRIG connector.
As soon as one sweep is finished, the next sweep is started. A
second trigger event stops the sweep at the current frequency, a
third trigger event starts the trigger at the start frequency, and so
on.
*RST:
AUTO
Example:
TRIG:FSW:SOUR EXT
selects triggering with an external trigger.
Manual operation:
See
:TRIGger<hw>:FSWeep[:IMMediate]
Immediately starts an RF frequency sweep cycle.
The command is only effective for sweep mode "Single" (
SOUR:SWE:FREQ:MODE
AUTO
in combination with
TRIG:FSW:SOUR SING
).
The command corresponds to the manual control "Execute Single Sweep".
TRIGger Subsystem
Содержание SMBV100A
Страница 1: ...R S SMBV100A Vector Signal Generator Operating Manual Operating Manual 1176 8016 02 17 ÚÞ 2 ...
Страница 31: ...Contents R S SMBV100A 16 Operating Manual 1176 8016 02 17 ...
Страница 129: ...Manual Operation R S SMBV100A 114 Operating Manual 1176 8016 02 17 Legend of Front Panel Controls ...