Rohde & Schwarz SMBV100A, Руководство по эксплуатации

Страница: 401 / 911

Instrument Function
R&S
®
SMBV100A
386 Operating Manual 1176.8016.02 ─ 17
The output is based on the waveform file that is loaded. The name of the waveform file
is displayed next to "Load Waveform".
If a multi segment waveform is loaded the section "Multi Segment Waveform Options"
is indicated. In this section, the segment to be output is selected.
If no waveform file is loaded, ARB modulation cannot be powered up. "None" will be
displayed next to "Load Waveform". An error message asks the user to load a wave-
form file:
"No waveform file loaded. ARB MOD state remains off. Please select a waveform file
to load, before switching ARB MOD state on."
Remote command:
[:SOURce<hw>]:BB:ARBitrary:STATe
on page 601
Set To Default
Calls default settings. The values are shown in the Table 5-10 .
Table 5-10: Default Settings
Parameter Value
State Off
Clock Freq. 1 MHz
Trigger Mode Auto
Trigger Source Internal
Marker State Off
Marker Mode Unchanged
Clock Source Internal
Remote command:
[:SOURce<hw>]:BB:ARBitrary:PRESet
on page 601
Load Waveform
Calls the "File Select "menu for loading the waveform file.
The files last used are listed in the "Recent Data Sets" section. The directory can be
selected from the center left section. All waveform files (file extension
*.wv
) available
from the selected directory are listed on the right side. The file info (tag contents and
multi segment state) for the selected file is displayed below the file section.
The "Select..." button selects the marked file. This file is loaded when the ARB modula-
tion is enabled ("State On").
The "File Manager..." button leads to the file manager.
Baseband Signal - Baseband Block