Panasonic MINAS A6N Series, Руководство по эксплуатации

Страница: 372 / 495

6-41 Rev.2.00
1
Before Using the Products
2
Preparation
3
Setup
4
Trial Run
5
Adjustment
6
When in T
rouble
7
Supplement
*1 The part “
○
” indicates Pr6.27 “Latched time of warning” and can set the time interval 1 to 10s or
no time limit. Note that the battery warning and the end of life warning have “no time limit.”
*2 Through Pr4.40 “Warning output select 1” and Pr4.41 “Warning output select 2,” select the
warning issued as the warning output signal 1 (WARN1) and signal 2 (WARN2). In case of
setting value 0, OR output of all warnings will be obtained. In addition, do not use the setup values
other than those listed in the above table.
*3 Each warning detection can be disabled by Pr6.38 “Warning mask setup” and Pr6.37 “Warning
mask setting 2.” The corresponding bits are indicated in the table. The warning detection will be
disabled by bit=1.
*4 When the single-turn absolute function is enabled, a battery alarm is not detected.
*5 Warnings can be cleared by using the alarm clear. While the alarm clear input (A-CLR) is kept
ON, the all existing warnings are always cleared.
*6 Invalidated when Pr6.97 “Function expansion setting 3” bit1 = 0.
1.When in Trouble
List of Warning Code