Panasonic MINAS A6N Series, Руководство по эксплуатации

Страница: 159 / 495

3-55
Note
Related page
・
A parameter is designated as follows:
Pr0.00
No. Class
・
For “ Attribute ”,refer to P.3-38 “ Details of Attribute ”.
・
P.2-47
〜
“ Wiring to the Connector
，
X4 ”
Default: [ ]
Rev.2.00
1
Before Using the Products
2
Preparation
3
Setup
4
Trial Run
5
Adjustment
6
When In T
roubie
7
Supplement
4. Details of Parameter
[Class 2] Damping Control
Pr2.04 2nd notch frequency
Range Unit Attribute Default
Related
control code
50 to 5000 Hz B 5000 P S T
Caution
Set the center frequency of the 2nd notch filter.
The notch filter function will be invalidated by setting up this parameter to "5000".
Pr2.05 2nd notch width selection
Range Unit
Attribute
Default
Related
control code
0 to 20 — B 2
P S T
Caution
Set the width of notch at the center frequency of the 2nd notch filter.
Higher the setup, larger the notch width you can obtain. Use with default setup in normal operation.
Pr2.06 2nd notch depth selection
Range Unit Attribute Default
Related
control code
0 to 99 — B 0
P S T
Set the depth of notch at the center frequency of the 2nd notch filter.
Higher the setup, shallower the notch depth and smaller the phase delay you can obtain.
Pr2.07 3rd notch frequency
Range Unit Attribute Default
Related
control code
50 to 5000 Hz B 5000 P S T
Caution
Set the depth of notch at the center frequency of the 3th notch filter.
In no resonance point is found, the frequency is set to 5000.Notch frequency is automatically
set to the 1st resonance frequency estimated by the adaptive filter.No resonance point was
found, set to 5000 .
Pr2.08 3rd notch width selection
Range Unit
Attribute
Default
Related
control code
0 to 20 — B 2 P S T
Caution
Set the width of notch at the center frequency of the 3rd notch filter.
Higher the setup, larger the notch width you can obtain. Use with default setup in normal operation.
When the applicable filter function is used, parameter value is automatically set.
Pr2.09 3rd notch depth selection
Range Unit
Attribute
Default
Related
control code
0 to 99 — B 0 P S T
Caution
Set the depth of notch at the center frequency of the 3rd notch filter.
Higher the setup, shallower the notch depth and smaller the phase delay you can obtain.
When the applicable filter function is used, parameter value is automatically set
.
Caution