Oridion Capnostream 20p, Руководство оператора

Страница: 64 / 141

Adjustable SpO2 Parameters
62 Portable Bedside Capnograph/Pulse Oximeter
Figure 26 - SpO
2
Section of Numeric Home Screen
Adjustable SpO
2
Parameters
The Capnostream monitor provides the option of adjusting some parameter settings used for SpO
2
measurement
to suit your patients, your institution's requirements, or other needs. To change these settings on a temporary
basis, until the device is turned off, follow the procedure below. To set changes as institutional defaults so that
the settings will remain in effect even after the monitor is turned off, see
Institutional Defaults on page 119.

T
O
C
HANGE
S
P
O
2
P
ARAMETER
S
ETTINGS
:
1. On the Home screen, move the control knob to the SpO
2
section of the screen, so that it is outlined in blue.
Click the control knob.
2. The SpO
2
Setup screen will appear. Move the control knob to the parameter that you wish to change and
click to select that parameter. Move the control knob to select the desired setting and click to select the
setting. A list of the settings that can be changed appears in
Table 12 - Adjustable SpO2 Parameters , below.
3. Move the control knob to the HOME button and click to select. The screen will also revert to the Home
screen after a few seconds if no additional actions are taken on that screen.
4. The changes in the parameters will remain in effect until the device is turned off.
Table 12 - Adjustable SpO
2
Parameters
Parameter Choices Factory Default
Pulse Tone On/Off On
Sat Sec (Sat Seconds) On/Off On
SpO2 Scale for Trend Display 0-100, 50-100 50-100
PR Scale for Trend Display 150, 300 150
Sweep Speed (mm/sec)
[for current patient type] 3, 6.3, 12.5, 25 25
SPO
2
Alarm Limit Message
When the SpO
2
alarm limit is set below 85%, a message reading SpO
2
LOW ALARM LIMIT: xx will appear in
the header area, indicating the level of the SPO
2
LOW alarm limit.
SpO
2
, Sat
Seconds and
Pulse Rate
values