Oridion Capnostream 20p, Руководство оператора

Страница: 33 / 141

Standard Sections of the Display Screen
Portable Bedside Capnograph/Pulse Oximeter 31

T
O TURN ON THE MONITOR
:
1. Plug the electrical cord into the mains plug in the rear of the monitor (see Figure 7 - Capnostream Rear View
on page 29 ). Clip the power cord strain relief around the cable and tighten to ensure that the power cord does
not accidentally disconnect from the monitor.
2. Plug the electrical cord into the mains AC supply.
3. The orange power indicator on the front panel will light up.
CAUTION: If the orange light is not on, the monitor is running on battery power only and will stop
operating when the battery is discharged.
4. Press the Power ON/OFF button on the front panel to turn on the monitor. The following happens:
•
The green power-on indicator lights up, showing that the monitor is turned on.
•
An hourglass figure appears on the screen for a few seconds followed by the blue monitor salutation
screen for about 5 seconds as the monitor performs a self-test.
•
The red alarm and yellow alarm lights will briefly light up and the speaker will beep.
CAUTION: If the red and yellow alarm lights do not light up or there is no sound from the speaker, the
monitor should not be used and should be sent for servicing.
•
You will hear the pump briefly turn on for a few seconds, and then turn itself off. However, if a FilterLine
is connected to the monitor, the pump will remain on.
Figure 9 - Salutation Screen
Standard Sections of the Display Screen
After the blue Salutation screen, a screen requesting that you clear the trend memory will appear. For an
explanation of that screen, see
Using Patient Cases and Patient ID on page 44 . Following that screen, the Home
screen will appear.