Baumuller b maXX BM5800, Руководство по параметрам

Страница: 314 / 816

Management
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
314
of 814
3.5
108.15
DISABLE OPERATION reaction code
This parameter is only relevant for axis units.
See also
Z
Drive management
–
from page 289
This parameter defines the response of the drive during the transition from the OPERA-
TION ENABLED to the SWITCHED ON state in the state machine for the device control-
ler.
For correct functioning of the braking procedures on the Quick Stop or Ramp-down
ramps, the speed controller must be adequately configured.
108.16
Status internal limits
This parameter is only relevant for axis units.
Status bit string for internal limits

Value Meaning
0 Inhibit drive immediately
1 Return to ramp-down ramp
2 Return to Quick Stop ramp
3 Return to current limit
NOTICE!
Do not use return to current limit during U/f operation
Bit # Meaning
0 1: Current/torque limited
1 1: Speed set value limited at speed controller input
2 1: Speed limited during set value generation
3 Reserved
4 1: Negative HW limit switch is set (even if not limited)
5 1: Positive HW limit switch is set (even if not limited)
6 1: Negative SW limit switch is set (target position was outside, now limited)
7 1: Positive SW limit switch is set (target position was outside, now limited)
8…31 Reserved