Baumuller b maXX BM5800, Руководство по параметрам

Страница: 263 / 816

Description of the Software Modules and Parameters
Parameter manual b maXX BM5800
Document No.: 5.16029.03
263
of 814
3
147.16
Torque init stress 1
Torque init stress of the slave drive at torque coupling at speed limit torque init stress
Z
147.17
–
(at slave functionality only, i.e.
Z
147.1
–
Bit 1...0 = 10, see
Z
Fig. 71
–
on page
254). If parameter
Z
147.1
–
Bit 12 is set, this additional torque takes effect correspond-
ingly (see
Z
Fig. 73
–
on page 256).
147.17
Speed limit torque init stress 1
Speed limit for the torque init stress 1
Z
147.16
–
at torque coupling (at slave functionality
only, i.e.
Z
147.1
–
Bit 1...0 = 10, see
Z
Fig. 71
–
on page 254). If parameter
Z
147.1
–
Bit 12 is set, this additional torque takes effect correspondingly (see
Z
Fig. 73
–
on page
256). The limit effects bipolar, thus means in both directions of revolution.
147.18
Torque init stress pt1 time constant
Time constant of PT1 element to connect the torque init stress to the slave at torque cou-
pling (at slave functionality only, i.e.
Z
147.1
–
Bit 1...0 = 10, see
Z
Fig. 71
–
on page 254).
147.19
Torque set value master
Display of the torque set value of the master at torque coupling in the dimensions for
transmission via fieldbus.
This parameter must be sent cyclic from the master to the slave.
At external master-slave communication this parameter must be sent via cross commu-
nication (fieldbus) or analog inputs/outputs. See also
Z
Cross communication
–
on page
256.
At internal master-slave communication an external transmission is not required.
NOTE!
The parameterized torque init stress is set only at the time when both the speed cou-
pling factor master and slave
Z
147.5
–
,
Z
147.6
–
are 1.