Baumuller b maXX BM5800, Руководство по параметрам

Страница: 281 / 816

Description of the Software Modules and Parameters
Parameter manual b maXX BM5800
Document No.: 5.16029.03
281
of 814
3
Example:
The position should be resolved in 0.1° increments and the speed in 0.1°/s increments,
without negation.
P 179.2 = 65536
P 179.3 = 1
P 179.4 = 65536
P 179.5 = 1
P 179.6 = 1
P 179.7 = 1
P 179.8 = 3600
P 179.9 = 1
NOTES!
m
Touch probe

The following settings must be set / considered if touch probe objects with a Factor
group standardization are used:
– Activate channels in parameter
Z
124.1
–
– Map activated channels on the Factor Group objects, DS402 touch probe
– Switch on and select scaling with Factor Group
m
Operating mode "Target Position Setting"

Only the relative target modes 4, 7, 9, 12 (see
Z
118.16
–
) are supported
m
The touch probe value of the standardized (by the Factor Group) non-positioning
encoder cannot be calculated correctly anymore, if the standardized (by the Factor
group) actual position value overflows. This is the case at devices with more than
one encoder per axis (single axis BM5300, mono device BM5500) and separate
encoders for motor and positioning control (
Z
18.9
–
bit 0 = 1).

If this overflow can not be excluded, the factor group must be switched off for this
encoder (
Z
124.30
–
), if one of the parameters
Z
124.31
–
to
Z
124.34
–
is intended
to be used for this encoder.
m
The functions "Modulo position actual value" and "Modulo position set value" are
not considered within the Factor Group
m
Accuracy

Position-rated values are in general up to 32 bit precise - at the writing or reading
of 16 bit exact target or source parameters an accuracy of 16 bit only is reached
(this refers to the following parameters:
Z
121.5
–
,
Z
136.3
–
,
Z
118.16
–
,
Z
120.3
–
,
Z
121.3
–
,
Z
121.4
–
and
Z
18.60
–
).

Speed and acceleration-rated values require a resolution of 16 bit.