Baumuller b maXX BM5800, Руководство по параметрам

Страница: 749 / 816

Error messages and troubleshooting
Parameter manual b maXX BM5800
Document No.: 5.16029.03
749
of 814
4
1516 Faulty init of scaling data No response
1517 Error during reading of the cyclic actual
values No response
1518 Error during writing of the cyclic set val-
ues No response
1519 Critical GDP error while initialization Incorrect reading or writing of important data via GPD. GPD means
the communication between controller and fieldbus controller. No response
1520 Invalid version of the controller firm-
ware Installed controller firmware cannot be used with this type of field-
bus. Version see controller parameter P102.2 or IDN P-0-0221 No response
1521 Warning: Error while reading service
data No response
1522 Warning: Error while writing service
data No response
1523 Error during command execution An error occurred during a command execution. No response
1524 Timeout during command execution A timeout occurred during a command execution. No response
1525 MST-Error; drive controller lost syn-
chronization Sercos: MST incorrect
SoE: controller signaled lost synchronization No response
1526 Error: MDT miss twice; watchdog time-
out process data Sercos: failure of MDT (MDT miss twice)
SoE: watchdog timeout at process data No response
1527 Error during switch up of phase Error during switch up of the bus state

(phase switch up)
No response
1528 Error during switch down of phase Error during switch down of the bus state

(phase switch down)
No response
1529 Phase transition without ready
acknowledge Sercos:
n
switch up to CP3 not possible

back to CP0.
n
switch up to CP4 not possible

back to CP0.
SoE:
n
switch up to Safe-Op not possible

back to Pre-OP.
n
switch up to Op not possible

back to Safe-OP.
No response
1530 Error: Invalid phase Invalid phase (bus state) set. No response
1531 Switch to non-initialized operation
mode Switch to a not supported or unknown operation mode. No response
1532 Error: Two drives with same address in
ring Error message only possible using Sercos. No response
1533 Error while reading sync data of drive
controller Error when adjusting the synchronization data with the settings in
the drive controller. No response
1534 Overflow mailbox service Overflow during a fragmented mailbox service. No response
1535 Invalid mailbox size Error detected when checking the mailbox size. No response
1536 to 1555: see Application Manual SoE slave for BM2500/3300/5000 (5.14010)
1609 too many repetitions with HIPER-
FACE

protocol
No response
1700 Error code directly according to error
report from encoder Pulse block
1701 Analog signals outside of specification
Calibration data are faulty Rotary encoder: Analog signals outside of specification
Linear encoder: Calibration data are faulty Pulse block
1702 Internal angle offset faulty Pulse block
1703 Table for data field partitioning
destroyed Pulse block
Error
num-
ber Brief error text Error description Default set-
ting for
Error
Response