Xerox Wide Format 6030, User Manual

Page: 182 / 448

Setting Up the Other Copy Presets
The other copy presets are used to set up additional, detailed copy presets. Enter the
[Code] number and the [New] parameters from the table below to set up the other system
presets.
Code Function New parameter Default
0 Sets the roll or tray from which to feed the
banner sheet. Roll 1: 0 Roll 2: 1
Roll 3: 2 Roll 4: 3
Roll 1:0
1 Sets up the length of the banner sheet. 210 to 15,000 mm 210 mm
2 Sets up the media type for the banner sheet. Ordinary: 0
Tracing: 1
Film: 2 Ordinary: 0
3 Determines whether or not to use the
smoothing function when printing. Yes: 1
No: 0 No: 0
4 Determines whether or not to use the
smoothing function when copying. Yes: 1
No: 0 No: 0
5 Sets up the default value for the cursor ([ ]
mark) on the control panel's [Independent
Portrait/Landscape Percentage] setup
screen.
Not set: 0
Portrait: 1
Landscape: 2 Portrait: 1
6 Determines whether or not to perform a
synchronized cut when printing a sample
copy. OFF: 0
ON (Synchronized Cut): 1 ON
(Synchronized
Cut): 1
Smoothing is a function that prints copies at a higher resolution (1200 dpi).The
smoothing function corrects jaggedness on angled lines and smooths images. This can
be set up separately for both copying and printing.
Halftones may print darker than usual when the smoothing function is used.