Wintriss SmartPAC 2, User Manual

Page: 500 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
H-22 Reporting Downtime and Scrap to SFC
Reporting Scrap and Good Parts to SFC
If you are running SFC-compatible firmware, SmartPAC 2 enables you to document scrap so
that scrap counts can be reported to SFC. The scrap counter, which appears on the Counters
screen in Run mode, maintains a cumulative total of all user scrap entries for the currently
running job, resetting to zero when the job is complete.
The cumulative scrap count reduces by that amount the number of good parts reported to SFC.
The good parts count is maintained in the Good Parts Count field on the Counters screen (see
Figure H-14, page H-23). If you wish to adjust the Good Parts counter upward, you can do so
in up to 1,000-part increments in Run mode and in larger increments in Program mode.
To enable scrap entries and Good Parts counter adjustments to be made in Run mode, you
must set the CHANGE COUNT and CHG GOOD PRTS CNT items on the Security Access
Menu in Initialization mode to “PROGRAM AND RUN MODES,” as shown in Figure H-13.
(To display the Security Access Menu, select SECURITY ACCESS from the Main
Initialization Menu–see Figure H-4, page H-8.)
If you want to allow scrap entries to be made in Run mode but prevent Good Parts counter
adjustments, you must set the CHG GOOD PRTS CNT item on the Security Access Menu to
“NO CHANGES ALLOWED” while leaving the CHANGE COUNT item set to
“PROGRAM AND RUN MODES.”
By default, the Good Parts counter does not increment during a fault condition. If you wish
the counter to increment even when there is a fault, set the COUNTER INCREMENT MODE
item on the Position Sensor screen to “INC ALWAYS” (see page 4-8).
Making Scrap Entries
To document scrap for a currently running job, do the following:
Figure H-13. Security Access Menu with CHANGE COUNT and CHG GOOD PRTS CNT
Items Set to “PROGRAM AND RUN MODES”
F1
F2
F3
F4
F5
F6
F7
F8