Wintriss SmartPAC 2, User Manual

Page: 141 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Installation 2-97
•
If the press does initiate the stroke, check the wiring of the palm buttons, correcting any
problems, then repeat step 4. If the press still initiates the stroke, call Wintriss Tech.
Support.
Anti-repeat Test
The anti-repeat test verifies that the press cycles only once when WPC 2000 is in
Single-stroke mode and both Run/Inch buttons are pressed simultaneously. To perform the
test, do the following:
1.
On the SmartPAC 2 front panel:
•
Turn the Program/Run key switch to RUN.
•
Turn the Stroke Select key switch of OFF.
•
Select TWO HAND on the Mode Select Menu (see page 6-40)
•
Turn the Stroke Select key switch to SINGLE STROKE.
2.
Press and hold down both Run/Inch palm buttons until the press completes a stroke and
for ten seconds after the press stops.
•
If the press makes one stroke and then top-stops, WPC 2000 is operating correctly. Go
to the next applicable test.
•
If the press cycles again after making one stroke, check the wiring of the Operator
Station and correct any problems; then, repeat the test. If the press still cycles after it
makes one stroke, call Wintriss Tech. Support.
INJURY DURING TESTING
• Keep all personnel away from the press during testing.
• Be sure there is no die or other tooling in the press during testing.
Failure to comply with these instructions will result in death or serious injury.
OPERATOR STATION MAY NOT MEET SAFETY REQUIREMENTS
• Ensure that the Operator Station is wired correctly.
• Ensure that on any non-Wintriss Operator Station the Run buttons are placed so that two hands
are required to push both buttons at the same time and no one can press both buttons with one
hand or with one hand and one elbow.
• Ensure that on any non-Wintriss Operator Station the Run buttons have ring guards or other
means in place to prevent unintentional operation.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!
DANGER
!