Wintriss SmartPAC 2, User Manual

Page: 107 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Installation 2-63
Connecting Programmable Cam Channels
If you have purchased the ProCamPAC option with SmartPAC 2, you have received a
separate output assembly for wiring up to sixteen cam channels to your equipment. The
assembly contains the relays that open and close at the angles you set in SmartPAC 2, turning
Table 2-21. DiPro Sensor Interface (DSI) 2 to SmartPAC 2 Wiring, Sensors 25-32
Wire color* 4th DSI 2 (TB2) DiProPAC (TB555)
Pin # Pin Designation Pin # Pin Designation
Brown 1 SENSOR 1 190 SENSOR 25
Red 2 SENSOR 2 191 SENSOR 26
Orange 3 SENSOR 3 192 SENSOR 27
Yellow 4 SENSOR 4 193 SENSOR 28
Green 5 SENSOR 5 194 SENSOR 29
Blue 6 SENSOR 6 195 SENSOR 30
Violet 7 SENSOR 7 196 SENSOR 31
Gray 8 SENSOR 8 197 SENSOR 32
No connection 198 Sensor power
Black 9 GND 199 GND
10 GND No connection
11 +5 VDC No connection
Shield Terminate drain wire to ground
stud
Terminate drain wire to ground
stud
* Your colors may be different.
If there are extra wires in the cable, cut them off close to the end of the cable jacket.
PROGRAMMABLE CAM SWITCH NOT FOR SAFETY USE
Use SmartPAC 2’s programmable cam switch to control auxiliary functions only. The SmartPAC 2
programmable cam capability should never be used to provide timing signals for any safety use
including clutch/brake control or muting of light curtains. Failure to comply with these instructions
will result in death or serious injury.
BOARD DAMAGE OR SHORT CIRCUIT WHEN MOUNTED WITHOUT ENCLOSURE
• Mount the cam output assembly in a clean area where it will be safe from damage.
• Provide at least 0.5 in. (12.7 mm) clearance between the back of the Cam Outputs board and
any metal surface.
Failure to comply with these instructions could result in property damage.
NOTICE
DANGER
!
CAUTION