Wintriss SmartPAC 2, User Manual

Page: 352 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
6-44 Run Mode
3.
Select one of the following options on the Mode Select Menu (see page 6-40):
•
Choose “TWO HAND” if you want to run the press in Two-hand mode
•
Choose “ONE HAND” if you want to run the press in One-hand mode
•
Choose “FOOT” if you want to run the press in Foot mode.
4.
Turn the Stroke Select switch to “SINGLE STROKE.”
Instructions for operating the press in each Single-stroke mode are provided below.
Single-stroke, Two-hand Operation
When performing the following procedure, make sure to press both Run/Inch buttons on each
installed Operator Station within the 1/2-second palm time (“synchronous” time in ANSI
terminology) and all pairs of Run/Inch buttons on all installed Operator Stations within the
5-second concurrent time. Also, confirm that the setting on S102 switch 6 is correct for your
Operator Station setup (see page 4-43).
To run the press, using Single-stroke, Two-hand operation, do the following:
If you are running Two-hand Only firmware, One-hand and Foot modes are not available.
OPERATOR STATION WIRED INCORRECTLY
Run all necessary tests to verify that each Operator Station is wired correctly and provides proper
anti-tie-down (see page 2-96) and anti-repeat (see page 2-97) protection.
Failure to comply with these instructions will result in death or serious injury.
MORE OPERATORS THAN OPERATOR STATIONS
• Ensure that there are the same number of active operator stations as there are operators if the
press is not equipped with properly installed and operating light curtains.
• During setup, lockout/tagout the press if there are more operators than operator stations.
• Verify at every shift change that there are the same number of active operator stations as there
are operators if the press is not equipped with properly installed and operating light curtains.
Failure to comply with these instructions will result in death or serious injury.
TWO-HAND CONTROL TOO CLOSE TO HAZARDOUS AREA
Verify at each shift change that any moveable Two-hand controls are located at least the safety
distance from the pinch point or hazardous area.
Failure to comply with these instructions will result in death or serious injury.
NOTICE
DANGER
!
DANGER
!
DANGER
!