Wintriss SmartPAC 2, User Manual, Page: 358 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
6-50 Run Mode
4.
To initiate the first stroke, depress the Prior Act button–the Prior Act lamp will blink when
Prior Act is armed–then press and hold the Run/Inch palm buttons until the ram passes
bottom dead center.
The up stroke and all other strokes will be automatic.
It is not unusual for the press to pause at Top Stop. It is waiting for the “go” signal from
the external switch.
The external signal must occur after Top Stop within the time selected on switch 5 (30
seconds or 5 minutes). If WPC 2000 does not receive the signal within this period, it
assumes a problem has occurred and will not start the next stroke. If this happens, repeat
step 4.
Operating the Press in Continuous Mode
To operate the press in Continuous mode, do the following:
1.
Make sure the Program/Run key switch is set to RUN.
2.
Turn the Stroke Select key switch of OFF.
3.
Select “TWO HAND” on the Mode Select Menu if you want to run the press in Two-hand
mode; select “FOOT” if you want to run the press in Foot mode (see page 6-40).
4.
Turn the Stroke Select switch to “CONT.”
Instructions for operating the press in each Continuous mode are provided below.
IMPROPER SAFEGUARDING
Ensure that the machine guarding system is installed and maintained according to OSHA
regulation 1910.217, ANSI standards B11.1 and B11.19, and any other regulations or standards
that apply. Ensure that guarding is properly installed to prevent access to the machine over, under
or around any guarding device.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!