Wintriss SmartPAC 2, User Manual

Page: 132 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
2-88 Installation
This section provides the tests you need to perform to verify that your WPC 2000 is installed
and set up correctly. These tests must be performed before you proceed to Chapter 4.
Perform the tests in order, skipping tests for optional components that do not apply to your
WPC 2000 setup. Use the “test” tool you created for setup procedures (see page 2-76).
If your WPC 2000 fails a test, you will be directed to follow step-by-step procedures to isolate
and correct the problem. If you are unable to correct a problem, contact Wintriss Tech.
Support for assistance.
Do not run the press until the problem has been corrected. Do not attempt to replace any
components in your new WPC 2000 unless instructed to by Wintriss Tech. Support.
In order to run the tests, you need to know how to operate the press in Inch, Single-stroke, and
Continuous modes using Two-hand, One-hand, or Foot control. Refer to the instructions
starting on page 6-39 if you need help running the press using these settings.
Many of the tests ask you to check the state of LEDs on the WPC 2000 Main Processor board
and status indicators on the screens available from the Display WPC Input Status screen (see
Input Status
, page 4-44). An LED map of the Main Processor board, showing the locations of
all LEDs, is provided in Figure 2-41, page 2-89. You access the Display WPC Input Status
screen by selecting PRESS CONTROL on the SmartPAC 2 Main Initialization Menu (see
Figure 2-38, page 2-73), then INPUT STATUS on the WPC Initialization Menu (see
Figure 4-18, page 4-23).
PRESS MUST BE IN “TOP-STOP IN INCH” MODE WHEN PERFORMING CHECKOUT TESTS
Make sure that there is no connection to pin #13 on the WPC 2000 Main Processor board before
running checkout tests. Top-stop in Inch must be enabled when performing these tests. See
page 6-42 for further details.
NOTICE