Wintriss SmartPAC 2, User Manual

Page: 392 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
7-30 Fault Messages
Fault message for red sensors: “This N/C sensor is open”
Problem:
A red sensor has actuated (i.e., is open to ground). When this message is
displayed, the angle at which the condition was detected is shown.
Remedy:
Check for the press or equipment malfunction that the sensor was supposed to
detect. If no malfunction has occurred, check for a problem with the sensor.
Check for loose or detached wiring at the DSI 2 or controller. Check for a severed
wire from the sensor to the DSI 2 or controller.
Miscellaneous Fault Messages
“Maximum press speed exceeded”
Problem:
The press is running at a speed greater than the maximum limit programmed for
this tool.
Remedy:
After clearing the error, either run the press at a slower speed, or adjust the limit
set in Program mode (see
PRESS CONTROL
, page 5-48).
“Minimum press speed exceeded”
Problem:
The press is running at a speed less than the minimum limit programmed for this
tool.
Remedy:
After clearing the error, either run the press at a higher speed, or adjust the limit
set in Program mode (see
PRESS CONTROL
, page 5-48).
“The resolver position is different from when the unit was turned off”
Problem:
This message will only appear if SmartPAC 2 detects that the resolver angle when
the press is turned on is different from the angle when the press was turned off.
This can happen when you move the press or upgrade SmartPAC 2 firmware.
Remedy:
Press RESET to clear. If the message reappears, call Wintriss Tech. Support.
“One of the sensor auto enable counters is greater than 99”
Problem:
Normally, this fault will never occur since SmartPAC 2 does not let you enter a
value greater than 99. However, this message could display if there is an internal
problem with SmartPAC 2.
Remedy:
First press RESET. If the message reappears, contact Wintriss Tech. Support.