Wintriss SmartPAC 2, User Manual

Page: 370 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
7-8 Fault Messages
Problem 2
: If the message accompanying the fault code is “ENERGY SAVER SHUT
DOWN,” the main motor has been turned off by WPC 2000 to save energy. You
will only get this message if you have wired the lockout relay to the motor starter
(see page 2-34) and specified a shutdown time on the Press Control Parameter
Menu in SmartPAC 2 Initialization (see page 4-32).
Remedy 2
: Clear the Lockout message, then turn the motor back on to reset the fault. Set the
press to Two-hand Inch operating mode to access Run mode without restarting the
motor. If you continue to get this message, you may need to increase the
Shutdown Time setting.
Problem
: The resolver moved when the output relays to the Dual Safety Valve (DSV) were
off (i.e., open) and the DSV was de-energized.
Remedy
: Check clutch, brake and DSV components for correct operation. Correct or repair
any malfunction.
Problem
: The Emergency Stop button on the WPC 2000 Operator Station has been
depressed, the E-Stop circuit was open after initiation of the stroke, or the E-Stop
relay circuits are not working properly.
Remedy
: If another control is connected to the WPC 2000 E-stop circuit, refer to the user
manual for that control to check for a specific error condition, and correct the
error. If the error persists, contact Wintriss Tech. Support.
Problem
: The Prior Act button on the Operator Station was depressed (i.e., switch was open)
after initiation of the stroke.
Remedy
: Press RESET. If the problem persists, check the wiring from the Operator Station
to WPC 2000. If necessary, Contact Wintriss Tech. Support.
F11*
F13
F14