Wintriss SmartPAC 2, User Manual, Page: 128 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
2-84 Installation
Run Menu, then press F3 (Show Overrun Angles) on the Press Control Parameters screen
(see Figure 6-24, page 6-31).
Example
If you mounted the magnet at an angle of 330°, the magnetic switch might come “on” at,
say, 321°, and go “off” at 337°.
10.
Run the press in Inch, Single-stroke, and Continuous modes for about 4 strokes each.
If the press cycles in every mode without a fault, go to step 11.
If a fault occurs while you are cycling the press in one or more modes, do the following:
•
If a fault occurs on the first stroke after you install the magnet, press RESET and
execute another stroke.
•
If the fault code is between F80 and F89 (or H80 through H89), there a problem with the
overrun sensor. Re-check your installation of the magnetic switch (see page 2-29) and
the magnet (see step 7) and your settings for option switches 1 and 2 (see steps 2 and 3),
then press RESET and run the press again for a few strokes. If the press stops and the
same error code displays, call Wintriss Tech. Support.
•
If another fault code displays, look up the fault in Chapter 7 and follow the suggested
remedy. After correcting the problem, press RESET and run the press again for a few
strokes, checking for faults. If you need assistance, contact Wintriss Tech. Support.
11.
Permanently install the magnet in the position in which you temporarily mounted it in step
7. Drill and tap a hole, using a No. 36 drill and 6-32 tap. Mount the magnet, plastic side
up, with the 6-32 brass screw provided.
12.
Cycle the press a few times in Single-stroke and Continuous modes to make sure it
operates without error.
INJURY FROM MAGNETS THAT DETACH
Mount the magnet with the brass screws provided. Plastic screws or adhesive could fail,
causing the magnet to become a dangerous projectile, especially on high-speed presses.
Failure to comply with these instructions could result in death or serious injury.
Use a brass or other non-ferrous screw to mount the magnet. Steel or ferrous screws can
cause false signals.
WARNING
!
NOTICE