Wintriss SmartPAC 2, User Manual

Page: 57 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Installation 2-13
which has three connectors altogether, including one for the DSV monitor that is already
installed. You wire the Reset solenoid and valve solenoid connectors to WPC 2000 as
shown in Figure 22.
Note that the DM2 Reset circuit is wired to the OFF position on the WPC 2000 Stroke
Select switch (see Figure 18). To reset the Ross DM2 DSV after an F47 error (see
page 7-14), press Reset/Select, and turn the Stroke Select switch to OFF, then back to one
of the other operating modes (i.e., Inch, Single-stroke, or Continuous).
Make sure to install air supply lines that match the inlet port size of the DM2 DSV to
provide sufficient air to reset the unit in case of a fault (see page 7-31).
•
Ross Serpar with EP Monitor
This Ross DSV requires a separate user-supplied reset switch. See Figure 17 at the end of
this manual. Also, all jumpers except those shown in the wiring diagram must be removed;
otherwise, the WPC 2000 Main Processor board may be damaged.
•
Herion XSZ
Make sure that you wire the Herion DSV monitor between pin #20 and a +24 Vdc output.
See Figure 16 at the end of the manual.
Installing Air Pressure Sensors or Switches
Your SmartPAC 2 with WPC 2000 requires either sensors or switches to monitor clutch air
pressure and counterbalance air pressure if there is a counterbalance. Wintriss offers two
pressure sensors with the unit, one for clutch air pressure, the other for counterbalance air
pressure (see Figure 2-7).
The following sections show you how to install air pressure sensors and switches.
DO NOT WIRE RESET CIRCUIT TO 110 VAC
The Reset circuit works only on 24 Vdc. Do not wire the Reset circuit to 110 Vac.
Failure to comply with these instructions could result in property damage.
Figure 2-7. Air Pressure Sensor
CAUTION
1 6 5 4 3 2
1/4 in. NPT
female threads
M12 connector