Wintriss SmartPAC 2, User Manual

Page: 225 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Initialization Mode 4-39
Switch 7 – Not Used
Switch 8 – Top-stop Mode for F and H Errors and Auxiliary Output 1 Response to
Interrupted Stroke
Switch 8 has two different functions. It controls how quickly the press top-stops when an F or
an H fault occurs, and if Auxiliary Output 1 on the WPC 2000 Main Processor board has been
wired, it also specifies how that output responds to an Interrupted Stroke condition.
SELECTING TOP-STOP MODE FOR F AND H ERRORS
One switch 8 function specifies whether the press takes an additional stroke before it top-stops
when an F or an H fault occurs after 210° (see Table 4-11).
When switch 8 is set to OPEN, its default setting, the press top-stops on the current stroke
when an F or H fault occurs before 210°, or takes an additional stroke before it top-stops if the
error occurs after 210°. When switch 8 is set to CLOSED, the press top-stops on the current
stroke if an F or H fault occurs at any angle.
CHANGES TO SWITCH 8 SETTING AFFECT BOTH SWITCH FUNCTIONS
When you change the option switch 8 setting for either the Top-stop or Auxiliary Output 1 function,
the new setting will affect operation of the other function.
PRESS MAKES ANOTHER STROKE AFTER BEING TOP-STOPPED ON F OR H ERROR
Use extreme caution if you set Switch 8 to OFF, which allows the press to complete another stroke
if an error occurs after 210°.
Failure to comply with these instructions will result in death or serious injury.
Table 4-11. Switch 8 Settings (S101): Top-stop Mode for F and H Errors
Setting Top-stop Behavior for F and H Errors
OPEN Normal operation (Default). Press top-stops on
current stroke when F or H fault occurs before 210°,
on next stroke if error occurs after 210°.
CLOSED Press top-stops on current stroke at whatever angle
an F or H error occurs.
NOTICE
DANGER
!