Wintriss SmartPAC 2, User Manual

Page: 148 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
2-104 Installation
This test verifies that your press and the light curtains connected to it operate correctly in
Continuous mode. To verify Continuous mode operation on a press without light curtains, go
to the next test (page 2-106). If your press does not run in Continuous mode, go to the next
applicable test. To run the Continuous mode test with light curtains, do the following,
referring to Figure 2-41 for LED locations and
Input Status
, page 4-44 for instructions in how
to access the Input Status screens:
1.
On the SmartPAC 2 front panel:
•
Turn the Program/Run key switch to RUN.
•
Turn the Stroke Select key switch of OFF.
•
Select TWO HAND on the Mode Select Menu (see page 6-40)
•
Turn the Stroke Select key switch to CONT.
Verify that the “CONT SEL” item on the WPC Buttons and Switches Input Status screen
is ON (see Figure 4-26, page 4-45).
2.
Verify that the light curtain is unobstructed and that the “Light curtain A1 input” and
“Light curtain A2 input” LEDs on the WPC 2000 Main Processor board are lit. (If you are
testing a second pair of light curtains, verify that “Light curtain B1 input” and “Light
curtain B2 input” LEDs are lit.) These LEDs turn off when the light curtain is obstructed.
3.
Press the Prior Act button on the Operator Station. The Prior Act lamp should illuminate,
then turn off after eight seconds.
•
If the Prior Act lamp turns off after eight seconds, go to step 4.
•
If the Prior Act lamp does not turn off after eight seconds, stop! Do not go any further!
Call Wintriss Tech. Support.
4.
Press the Prior Act button and, before the indicator lamp goes out, press both Run/Inch
palm buttons, releasing them after bottom dead center on the first stroke. The press should
continue running.
•
If the press continues to run, go to the next step.
•
If the press stops, check the wiring of the palm buttons, correct any problems, press and
hold both Run/Inch buttons to return the ram to top dead center, and run the test again.
If the press still stops, call Wintriss Tech. Support.
5.
Press the Emergency Stop button on the Operator Station. The ram should stop
immediately, the F13 fault code should appear on the SmartPAC 2 LCD, and the
Interrupted Stroke message should display. If these conditions are not present, check the
wiring of the Operator Station, particularly the E-stop wiring, and correct any problems.
Rerun this test from step 4. If the conditions are still not present, call Wintriss Tech.
Support.
RESET EMERGENCY-STOP BUTTON AFTER USE
The Emergency-stop button is not spring-loaded. You must pull it up to its original position
to reset the Emergency-stop (F13) fault.
NOTICE