Wintriss SmartPAC 2, User Manual

Page: 303 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Program Mode 5-49
The maximum and minimum speed limit settings are provided to allow programming of tools
run on a variable-speed press. They apply to all Run operating modes–Continuous,
Single-stroke, and Inch. When the speed of the press exceeds the maximum limit, SmartPAC
2 stops the press and displays the fault message “Maximum press speed exceeded.” When
press speed drops below the minimum limit, SmartPAC 2 stops the press and displays the fault
message “Minimum press speed exceeded.” These fault message are documented in Chapter
7 (see page 7-30).
The counterbalance setpoint is used together with the counterbalance tolerance you set in
Initialization (see
Setting Clutch and Counterbalance Air Pressure Limits
, page 4-29) to
specify the pressure range outside of which an F46 (Counterbalance Air Outside Sensor
Limits) error displays on the SmartPAC 2 LCD. This field will not display if the Initialization
tolerance value is set to zero (0).
To make settings on this screen, do the following:
1.
Select PRESS CONTROL on the Tool Program Menu. The Press Control Parameters
screen displays.
Figure 5-56. Press Control Parameters Screen
If this display appears, you need to enter the general password to program press speed
settings. Security access is set in Initialization mode (see
SECURITY ACCESS
,
page 4-47).
Figure 5-57. “Enter Your Password” Screen
ENTER YOUR PASSWORD
USE THE KEYPAD TO ENTER NUMBERS.
USE THE UP/DOWN CURSOR KEYS TO
INCREASE/DECREASE. PRESS ENTER
WHEN DONE. PRESS RESET TO CANCEL.
60599